Full-surface adhesive plaster/window-sealing tape, for exterior use

CONTEGA SOLIDO EXO

Advantages

  • Saves time: the joint is immediately resistant to driving rain and can be subjected to loading
  • Can be plastered over directly: defined transition between window and/or wind sealing and plasterwork
  • Reliable joints: water-resistant SOLID adhesive has extremely strong adhesion on mineral subsurfaces too
  • Proven resistance to driving rain up to 2400 Pa
  • Independently confirmed suitability: tests in accordance with MO-01/1 passed at IFT in Rosenheim, Germany

Areas of application

For exterior windtight joints that are resistant to driving rain between membranes or wood-based panels and windows, doors and mineral surfaces. The modified water-resistant SOLID adhesive ensures quick and permanent adhesion to the subsurface. The stuck joint is immediately windproof and can be subjected to loading. The fleece can simply be plastered over in accordance with the installation instructions.

Split of the release film

Tape width Split (approx.)
80 mm (3 1/8") 20 | 60 mm (7/8" | 2 3/8")
100 mm (4") 20 | 40 | 40 mm (7/8" | 1 5/8" | 1 5/8")
150 mm (5 7/8") 20 | 70 | 60 mm (3/4" | 2 3/4" | 2 3/8")
200 mm (7 7/8") 20 | 100 | 80 mm (3/4" | 4" | 3 1/8")

Installation instructions

Substrate

Clean subsurfaces before sticking. Uneven mineral subsurfaces may need to be levelled with a smooth finish. Adhesion to frozen surfaces is not possible. There must be no water-repellent substances (e.g. grease or silicone) on materials to be bonded. The width of the adhesive tape that is to be plastered over should generally not exceed 60 mm (2 3/8") or 50% of the soffit area. Detailed recommendations can be obtained from the relevant plaster producer. Subsurfaces must be sufficiently dry and stable.

Permanent adhesion is achieved on all pro clima interior membranes and on other vapour-check and airtight membranes (e.g. those made of PE, PA, PP and aluminium).
Adhesion can be carried out on planed and painted wood, hard plastics, hard wood-based panels (chipboard, OSB and plywood panels), metal (e.g. pipes, windows etc.), rigid foam insulation materials that can be plastered over, and on mineral subsurfaces such as concrete and masonry.

The best results in terms of structural stability are achieved on high-quality subsurfaces. It is your responsibility to check the suitability of the subsurface; adhesion tests are recommended in certain cases. Pre-treatment with TESCON PRIMER is recommended in the case of subsurfaces with insufficient stability.

General conditions

The bonds should not be subjected to tensile strain. Rub the adhesive tapes firmly to secure the adhesive bonds. Ensure that there is sufficient resistance pressure. Seals that are windproof and resistant to driving rain can only be achieved if the sealing tape is installed free of folds and breaks.
When plastering, please observe the recommendations of the plaster manufacturer for non-absorbent subsurfaces. A bonding course may be necessary.



Downloads

relating to our window-sealing products