TESCON TANGO
Self-adhesive patch for interior corners for interior and exterior use
Advantages
- Saves time: simple installation thanks to innovative positioning zone
- More flexible work: now also works for angles other than right angles
- Can be easily adapted using a knife or scissors
- Adheres reliably - even if moisture is present: water-resistant SOLID adhesive
- Subsequent work can be carried out with increased flexibility: 6 months of outdoor exposure
- Subsequent work can be started quickly: fleece backing can be plastered over directly
- Construction in adherence with standards: for airtight sealing in accordance with DIN 4108-7, SIA 180 and RE 2020
- Excellent values in hazardous substance testing, has been tested according to the ISO 16000 evaluation scheme
Areas of application
Self-adhesive patch made with TESCON adhesive tape for interior corners for sealing in indoor and outdoor areas. Adhesion to
- Vapour check and airtight membranes made of film and paper
- Vapour check and airtight membranes made of hard wood-based panels
- Underlay and breather (WRB) membranes
- Wood-fibre underlay panels (pre-treatment with TESCON PRIMER)
- Adjacent building components made of planed wood, hard plastics or metals, such as windows, doors, beams, ties etc.
Installation instructions
Installation steps: Room corner
Installation steps: skylights
Substrate
Clean subsurfaces before sticking. Adhesion to frozen surfaces is not possible. There must be no water-repellent substances (e.g. grease or silicone) on surfaces where adhesives are to be applied. Subsurfaces must be sufficiently dry and stable.
Permanent adhesion is achieved on all pro clima interior and exterior membranes, on other vapour check and airtight membranes (e.g. those made of PE, PA, PP and aluminium) and on other underlay and breather (WRB) membranes (e.g. those made of PP and PET).
Adhesive bonds are possible with planed and painted wood, hard plastics and metal (e.g. pipes, windows etc.) and hard wood-based panels (chipboard, OSB, plywood, MDF and wood-fibre underlay panels). Pre-treatment with TESCON PRIMER is required in the case of adhesion to wood-fibre underlay panels or on smooth, mineral subsurfaces. Concrete or plaster subsurfaces must not be sandy or crumbling.
The best results in terms of structural stability are achieved on high-quality subsurfaces. It is your responsibility to check the suitability of the subsurface; adhesion tests are recommended in certain cases.
Pre-treatment with TESCON PRIMER is recommended in the case of subsurfaces with insufficient stability.
General conditions
Taped joints should not be subjected to tensile forces. Rub the adhesive tapes firmly to secure the adhesive bonds. Ensure that there is sufficient resistance pressure. Windproof, airtight or rainproof sealing can only be achieved on vapour checks, roofing underlays or breather (WRB) membranes that have been laid without folds or creases.
Ventilate continuously and systematically to prevent build-up of excessive humidity; use a dryer if necessary.
