TESCON INCAV
Self-adhesive 3D shaped element for interior corners for interior and exterior use
Advantages
- Stick corners in a simple, reliable manner with a prefabricated shaped element
- Adheres reliably, even if moisture is present: water-resistant SOLID adhesive
- Flexible application: Can be adapted to suit individual requirements
- Corner can be folded over: adhesive area can face inwards or outwards
- Easy to work with, even for non-angled joints: very malleable
- Subsequent work can be carried out with increased flexibility: 6 months of outdoor exposure
- Construction in adherence with standards: for airtight sealing in accordance with DIN 4108-7, SIA 180 and RE 2020
- Excellent values in hazardous substance testing, has been tested according to the ISO 16000 evaluation scheme
Areas of application
Self-adhesive three-dimensional shaped element for interior corners consisting of TESCON adhesive tape for sealing in indoor and outdoor areas. Adhesion to
- Vapour control and airtight membranes made of film and paper
- Vapour control and airtightness layers consisting of hard wood-based panels
- Underlay and breather (WRB) membranes
- Wood-fibre underlay panels (pre-treatment with TESCON PRIMER)
- Adjacent building structures consisting of planed wood, hard plastics or metals, such as windows, doors, beams, ties etc.
Installation instructions
Installation steps
General conditions
The bonds must not be subjected to tensile forces.
Rub the adhesive tapes firmly to secure the adhesive bonds. Ensure that there is sufficient resistance pressure.
Windproof, airtight or rainproof sealing can only be achieved on vapour control membranes, roofing underlays or breather (WRB) membranes that have been installed without folds or creases.
Ventilate continuously and systematically to prevent build-up of excessive humidity; use a dryer if necessary.
Substrate
Clean subsurfaces before sticking. Adhesion to frozen surfaces is not possible. There must be no water-repellent substances (e.g. grease or silicone) on surfaces where adhesives are to be applied. Subsurfaces must be sufficiently dry and stable.
Permanent adhesion is achieved on all pro clima interior and exterior membranes, other vapour control and airtight membranes (e.g. those made of PE, PA, PP and aluminium) as well as other roof and breather (WRB) membranes (e.g. those made of PP and PET). Adhesive bonds are possible on planed and painted wood, hard plastics and metal (e.g. pipes, windows etc.), hard wood-based panels (chipboard, OSB, plywood, MDF and wood-fibre underlay panels). Pre-treatment with TESCON PRIMER is required in the case of adhesion to wood-fibre underlay panels and smooth mineral subsurfaces. Concrete or plaster subsurfaces must not be sandy or crumbling.
The best results in terms of structural stability are achieved on high-quality subsurfaces. It is your responsibility to check the suitability of the subsurface; adhesion tests may be necessary. Pre-treatment with TESCON PRIMER is recommended in the case of subsurfaces with insufficient stability.
