Exterior connection plastering tape

 

Advantages

  • Vapour permeable sealing of outdoor window and door joints
  • Active moisture transport by means of the monolithic TEEE functional membrane
  • Combines well with CONTEGA SL indoors
  • Can be plastered over on the fleece side with three adhesive tapes it is very versatile in timber, masonry and concrete structures
 

Application

For exterior wind-proof sealing of thermally insulated joints when installing windows and doors. In combination with CONTEGA SL also suitable for sealing joints in timber, masonry and concrete structures.

  Material
Backing double-layer special membrane made of PP fleece and TEEE functional film
Adhesive special acrylate adhesive
Attribute Value Norm
Colour dark grey
sd-value 0.05 m EN ISO 12572
g-value 0.25 MN⋅s/g
Vapor permeance 65.6 US perms ASTM E 96
Exposure time 3 months
Water column > 2 500 mm ; > 8' 2" EN 20811
Resistance to driving rain up to 600 Pa, surrounding ift, MO-01/1:2007-01, Abs. 5
Application temperature above -10 °C ; 14 °F
Temperature resistance permanent -40 °C to 90 °C ; -40 °F to 194 °F
Storage cool and dry

General conditions

The bonds should not be subjected to tensile strain.
Press firmly to secure the adhesive tape. Ensure there is sufficient back-pressure.
Driving rainproof and windtight seals can only be achieved if this connection tape is laid without folds or creases and are uninterrupted.

Substrate

Before sticking, subsurfaces should be brushed off, wiped clean with a cloth or cleaned using compressed air.
Bonding to frozen surfaces is not possible. There must be no water-repellent substances (e.g. grease or silicone) on materials to be bonded. Subsurfaces must be sufficiently dry and have sufficient load-bearing capacity.

Permanent adhesion is achieved on all pro clima exterior membranes and on other underlay/sarking and wall lining membranes (e.g. those made of PP and PET). Adhesion can be carried out on planed and painted wood, hard plastics, hard wood-based panels (chipboard, OSB and plywood panels).
For bonding joints on masonry or concrete or on rough substrates, use ORCON F.

The best results in terms of structural stability are achieved on high-quality subsurfaces.
It is your responsibility to check the suitability of the subsurface; adhesion tests are recommended in certain cases.
Pretreatment with TESCON PRIMER is recommended in the case of subsurfaces with insufficient load-bearing capacity.

Accessoires