Homogeneously weldable pipe grommet in the SOLITEX WELDANO roof lining system
- Homogeneously weldable in the SOLITEX WELDANO system with a welding liquid or with heat
- The pipes can be shifted or pulled subsequently without damaging the seal
- Extremely high tear-resistance
- Windproof, rainproof and watertight
- For pipes with diameters of 90 - 125 mm (3.5" - 5")
For reliable installation of pipe feed-throughs within the SOLITEX WELDANO system. Suitable for roof pitches between 5° and 25°. The prefabricated grommet can be used to execute pipe feed-throughs in an easy, quick and permanently sealed manner.
The shaped element can be welded to the pro clima SOLITEX WELDANO roof lining membrane in a watertight manner using the WELDANO TURGA system solvent welding agent or hot air.
When carrying out adhesion using hot air or a solvent welding agent, press the membranes firmly into place using a plastic roller, taking care to ensure that there is sufficient resistance pressure.
Rainproof and waterproof adhesion can only be achieved on roof lining membranes that have been installed with no folds or creases.
Before adhesion, SOLITEX WELDANO should be wiped clean with a cloth.
Bonding to frozen surfaces is not possible. There must be no water-repellent substances (e.g. grease or silicone) on the membranes. Subsurfaces must be sufficiently dry and have sufficient load-bearing capacity.
It is recommended that spot checks be performed to test the strength of the stuck joints.